Roof Access Safety Plan

Roof access careful planning and using the correct method and suitable equipment to access roofs will reduce the risk of falls when working on a roof.

Roof access safety plan.

Low slope roof 4 12 slope or less 29 cfr 1926 501 b 10. Taylor company a roofing contractor. Scaffold access towers stair towers industrial grade secured ladders and roof access hatches. Written safety information and the work plan shall be kept for the duration of the job.

In any situation where the roof of a building has no edge protection a building owner needs to secure the safety of the people who have to access the roof. Should a deficiency be found access to the roof or the part of the roof with the problem should be denied until the hazard has been abated. On a set basis somebody should be going to the roof with a buddy for the sole purpose of inspecting it. Employers need to plan ahead to get the job done safely employers need to develop a plan and ensure the proper equipment material and appropriately trained workers are available.

Providing proper instruction as well as having an adequate rescue plan in place are required and the building owners liability. High safety standards are essential for roof access work and the nature of the precautions required must be assessed for each individual job. When working in the control zone fall protection equipment must be used. Other things such as roof mounted anchor points require periodic inspections.

All roofs should be treated as fragile until a competent person has confirmed they are not. Know the pitch of the roof and follow the appropriate standard. This procedural guidance sets out responsibilities precautions and provides general guidance for good practice relevant to all roof access work. Exterior egress beyond ladders staff should exercise situation awareness when accessing the roof via hatches elevators penthouse doors scaffolding or power equipment such as scissor lifts and aerial work platforms says brad richardson a certified safety professional and director of environmental health and safety for d.

Assessing all work at height. Fall arrest and safety nets slung beneath and close to the roof. The department of environmental health safety if roof top access opens into the control zone guard rails must be installed to protect the worker until they have entered the safe zone. It is the responsibility of the lead contractor or principal to inform all workers on site that they must adhere to the requirements of the work plan and safety information and the before any person seeks or gains access to the roof.

Roof access prepared by.